R&S FSL CDMA2000 Base Station Measurements (Option K82)
1300.2519.12 2.117 E-11
Test setup:
Connect the RF output of the signal generator to the RF input of the R&S FSL (coaxial cable with N
connectors).
Signal generator settings:
Frequency: 878.49 MHz
Level: 0 dBm
Standard: CDMA2000
Procedure:
1. Set the R&S FSL to its default state.
Press the PRESET key.
2. Activate the CDMA2000 BTS Analyzer mode.
Press the MODE key and activate the CDMA2000 BTS Analyzer option.
3. Start the Power measurement
Press the MEAS key.
Press the Power softkey.
4. Set the center frequency.
Press the FREQ key and enter 878.49 MHz.
5. Set the reference level.
Press the AMPT key and enter 0 dBm.
On the screen, the spectrum of the signal and the corresponding power levels within the 1.2288 MHz
channel bandwidth are displayed. In the table below the diagram, the numeric values of the channel
bandwidth of the TX xhannel and power level of the analyzed signal are listed.
Fig. 2-82: Measurement of the signal channel power
To Next Page
Loading...
