CDMA2000 Base Station Measurements (Option K82) R&S FSL
1300.2519.12 2.120 E-11
Procedure:
1. Set the R&S FSL to its default state.
Press the PRESET key.
2. Activate the CDMA2000 BTS Analyzer Mode.
Press the MODE key and select CDMA2000 BTS Analyzer.
3. Enter the Code Domain Analyzer.
Press the MEAS key
Press the Code Domain Analyzer softkey.
4. Start the measurement
In the Code Domain Analyzer softkey menu, press the Select Meas softkey.
Press the Code Domain Power softkey.
5. Enter the Settings Overview dialog box.
Press the Settings softkey.
Press the Settings Overview softkey.
The Settings Overview dialog box is displayed.
6. Set the center frequency and the reference level.
In the Settings Overview dialog box select the Frontend button.
In the Center Frequency field enter 878.49 MHz.
In the Ref Level field enter 10 dBm.
Close the Frontend Settings dialog box.
Close the Settings Overview box.
In the two screens, the following results are displayed: screen A shows the power of the code domain of
the signal. The x-axis represents the individual channels (or codes), while the y-axis shows the power of
each channel. In screen B the result summary is displayed. It shows the numeric results of the code
domain power measurement, including the frequency error.
To Next Page
Loading...
