Rohde & Schwarz R&S FSL3 - Page 1473

FETCh Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.714 E-11
Returned values for IEEE 802.11b & g (CCK)
<min rise time>,<average rise time>,<max rise time>,
<min fall time>,<average fall time>,<max fall time>,
<min rms power>,<average rms power>,<max rms power>,
<min peak power>,<average peak power>,<max peak power>,
<min crest factor>,<average crest factor>,<max crest factor>,
<min frequency error>,<average frequency error>, <max frequency error>,
<min chip clock error>, <average chip clock error>, <max chip clock error>,
<min phase error>, <average phase error>, <max phase error>,
<min IQ offset>, <average IQ offset>, <maximum IQ offset>,
<min gain imbalance>, <average gain imbalance>, <max gain imbalance>,
<min quadrature offset>, <average quadrature offset>, <max quadrature offset>,
<min EVM IEEE>, <average EVM IEEE>, <max EVM IEEE>,
<min EVM Direct>, <average EVM Direct >, <max EVM Direct >
FETCh:BURSt:ALL?
This command returns all the results. The results are output as a list of result strings separated
by commas in ASCII format. For details on the format refer to "ASCII formats for returned
values" on page 6.713. The units for the EVM results are specified with the UNIT:EVM
command.
Example
FETC:BURS:ALL?
All calculated results are returned
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
FETCh:BURSt:COUNt?
This command returns the number of analyzed bursts.
This command is a query only and thus has no *RST value.
Example
FETC:BURS:COUN?
The analyzed number of bursts are returned
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN