Rohde & Schwarz R&S FSL3 - Page 1524

R&S FSL CALCulate:LIMit Subsystem (WiMAX, K92/K93)
1300.2519.12 6.765 E-11
C
haracteristics
RST value: –
SCPI: device–specific
M
ode
OFDM, OFDMA/WiBro
CALCulate<1|2>:LIMit<1...8>:BURSt:EVM:DATA[:AVERage]
This command sets the average Error Vector Magnitude Limit for the data carrier.
The numeric suffixes <1|2> sets the measurement window for the calculation and the suffixes
<1...8> specify the limit lines (see CALCulate<1|2>:LIMit<1...8>:FAIL? command).
Parameter
–1000000 to 1000000 dB or %
If no unit is specified the unit specified by the UNIT:TABLe command is used.
Example
CALC:LIM:BURS:EVM:DATA –30.0
Average EVM for data carrier limit is set to –30.0 dB.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CALCulate<1|2>:LIMit<1...8>:BURSt:EVM:DATA[:AVERage]:RESult?
This command returns the average Error Vector Magnitude limit result summary for the data
carrier in dB.
The numeric suffixes <1|2> sets the measurement window for the calculation and the suffixes
<1...8> specify the limit lines (see CALCulate<1|2>:LIMit<1...8>:FAIL? command).
This command is only a query and therefore has no *RST value.
Return values
0 PASSED
1 FAILED
Example
CALC:LIM:BURS:EVM:DATA:RES?
Average EVM for data carrier limit result is returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro