WLAN TX Measurements – Programming Examples (Option K91/K91n) R&S FSL
1300.2519.12 7.34 E-11
WLAN TX Measurements – Programming Examples
(Option K91/K91n)
The following section provides some examples of commonly performed operations when using the
WLAN TX Measurements option (K91/K91n). For more general remote control examples refer to the
programming examples in this chapter.
This option is available from firmware version 1.20.
Synchronization Entry of Option
The following example shows how to synchronize entering the WLAN TX Measurements option.
analyzer = 20 'Instrument address
CALL InstrWrite(analyzer, "INST:SEL WLAN;*OPC?")
'waits for 1 from *OPC?
Selecting Measurements
Measurements are selected using the command CONFigure:BURSt:<Meas Type> where <Meas
Type> is as follows:
<Meas Type> Measurement Type
PVT Power vs Time (PVT)
PVT:SELect EDGE PVT rising and falling edge
PVT:SELect FULL PVT full burst (802.11a only)
PVT:SELect RISE PVT rising burst (802.11b only)
PVT:SELect FALL PVT falling burst (802.11b only)
EVM:ECARrier EVM vs Carrier
EVM:ESYMbol EVM vs Symbol
SPECtrum:MASK Spectrum Mask
SPECtrum:MASK:SELect IEEE Spectrum Mask IEEE
SPECtrum:MASK:SELect ETSI Spectrum Mask ETSI
SPECtrum:FLATness Spectrum Flatness
SPECtrum:FFT Spectrum FFT
SPECtrum:ACPR Spectrum ACPR
CONstellation:CCARrier Constellation vs Carrier
CONstellation:CSYMbol Constellation vs Symbol
STATistics:CCDF CCDF
To Next Page
Loading...
