R&S FSL Maintenance
1300.2519.12 8.1 E-11
8 Maintenance
The following chapter contains information on the maintenance of the R&S FSL. The instrument does
not need a periodic maintenance. What is necessary is essentially the cleaning of the instrument.
However, it is recommended to check the rated data from time to time.
Follow the instructions in the service manual and the safety instructions when exchanging modules or
ordering spares. The order no. for spare parts is included in the service manual. The service manual
includes further information particularly on troubleshooting, repair, exchange of modules (including
battery exchange, adjustment of the OCXO oscillator) and alignment.
The address of our support center and a list of all Rohde & Schwarz service centers can be found at the
beginning of this manual.
Storing and Packing
The storage temperature range of the instrument is given in the data sheet. If the instrument is to be
stored for a longer period of time, it must be protected against dust.
Repack the instrument as it was originally packed when transporting or shipping. The two protective
foam plastic parts prevent the control elements and connectors from being damaged. The antistatic
packing foil avoids any undesired electrostatic charging to occur.
If you do not use the original packaging, provide for sufficient padding to prevent the instrument from
slipping inside the package. Wrap antistatic packing foil around the instrument to protect it from
electrostatic charging.
List of Power Cables Available
Table 8–1 List of power cables available
Stock No. Earthed–contact connector Preferably used in
DS 006.7013.00 BS1363: 1967' complying with
IEC 83: 1975 standard B2
Great Britain
DS 006.7020.00 Type 12 complying with SEV–regulation
1011.1059, standard sheet S 24 507
Switzerland
DS 006.7036.00 Type 498/13 complying with
US–regulation UL 498, or with IEC 83
USA / Canada
DS 006.7107.00 Type SAA3 10 A, 250 V,
complying with AS C112–1964 Ap.
Australia
DS 0025.2365.00
DS 0099.1456.00
DIN 49 441, 10 A, 250 V, angular
DIN 49 441, 10 A, 250 V, straight
Europe (except Switzerland)
To Next Page
Loading...
