Cable TV Measurements (Option K20) R&S FSL
1300.2519.12 4.236 E-11
Remote: ATV:CN:MEAS:MODE OSER (Measurement Method)
Remote: ATV:CN:TABL1:MFR 1,1000,1000 (Measurement Frequencies)
Remote: ATV:CN:BWID 7MHZ (Noise Reference Bandwidth)
Remote: ATV:CN:POW:NCOR ON (Noise Floor Correction)
Insert Line
Inserts a line in the Measurement Frequencies table to add a parameter set. This softkey is
only active, if the focus is on the Measurement Frequencies table.
Delete Line
Deletes the focused line in the Measurement Frequencies table. This softkey is only active, if
the focus is on the Measurement Frequencies table.
Next Meas Frequency
Switches from one frequency span to the next according to the parameter sets (center
frequency, span) defined under Measurement Frequencies in the setup dialog box. Only
activated entries are considered.
Remote: ATV:CN:CFR:NEXT
Remote: ATV:CSO:CFR:NEXT
Remote: ATV:CTB:CFR:NEXT
To Next Page
Loading...
