R&S FSL CDMA2000 BTS Analyzer (Option K82)
1300.2519.12 4.301 E-11
Transferred parameter
# of Adjacent Channels
Sweep Time
Span
Fast ACP Mode
For details on the softkeys of the Adjacent Channel Power measurement refer to the Adjacent
Channel Power softkey in the measurement menu.
Spectrum Emission Mask (see Spectrum Emission Mask softkey)
The default settings of the Spectrum Emission Mask measurement are listed in the table below.
Setting Default value
Frequency Span 8 MHz
Sweep Time 100 ms
Detector RMS
In order to provide a quick swap from the base unit to the CDMA2000 BTS Analyzer option,
some parameters are passed on.
Transferred Parameter
Reference Level
Ref Level Offset
Center Frequency
Frequency Offset
Trigger settings
For details on the softkeys of the Spectrum Emission Mask measurement refer to the
Spectrum Emission Mask softkey in the measurement menu.
Occupied Bandwidth
The Occupied Bandwidth measurement determines the bandwidth in which the signal power
can be found. By default the bandwidth is displayed in which 99% of the signal is found. The
percentage of the signal power included in the measurement can be modified.
In the top right corner of the screen, the bandwidth and frequency markers are displayed.
The default settings of the Occupied Bandwidth measurement are listed in the table below.
Setting Default value
Occupied Bandwidth ON
Frequency Span 4.2 MHz
Sweep Time 100 ms
RBW 30 kHz
VBW 300 kHz
Detector RMS
In order to provide a quick swap from the base unit to the CDMA2000 BTS Analyzer option,
some parameters are passed on.
To Next Page
Loading...
