Introduction R&S FSL
1300.2519.12 5.2 E-11
The modules visa32.bas and vpptype.bas can be found in the <VXIpnpPath>\WinNT\include (typically
C:\VXIpnp\WinNt\include).
Note: Manual operation is designed for maximum possible operating convenience. In contrast, the
priority of remote control is the "predictability" of the device status. Therefore, control programs
should always define an initial device status (e.g. with the command *RST) and then implement
the required settings.
To make remote control operation more comfortable and faster, you can use IVI drivers. They bundle
remote control commands, reduce the I/O to the instrument by status caching, check status and
parameters and offer simulation modes.
To Next Page
Loading...
