SENSe Subsystem R&S FSL
1300.2519.12 6.174 E-11
[SENSe<1|2>:]AVERage:COUNt:AUTO
This command is implemented only for reasons of compatibility with the FSP family. It selects a
suitable number of counts for the selected measurement type.
The numeric suffixes <1|2> are not relevant.
Parameter
ON | OFF
Example
AVER:COUN:AUTO ON
Characteristics
RST value: OFF
SCPI: conform
Mode
all
[SENSe<1|2>:]AVERage:TYPE
This command selects the type of average function.
Parameter
VIDeo The logarithmic power values are averaged.
LINear The power values are averaged before they are converted to logarithmic values.
Example
AVER:TYPE LIN
Switches to linear average calculation.
Characteristics
RST value: VIDeo
SCPI: device–specific
Mode
A
To Next Page
Loading...
