Rohde & Schwarz R&S FSL3 - Page 990

R&S FSL SENSe Subsystem
1300.2519.12 6.231 E-11
C
haracteristics
*RST value: OFF
SCPI: device–specific
M
ode
A, WLAN, OFDM, OFDMA/WiBro
[SENSe<1|2>:]SWEep:EGATe:HOLDoff
This command defines the delay time between the external gate signal and the continuation of
the sweep.
The numeric suffixes <1|2> are not relevant.
Parameter
125 Us to 100 s
Example
SWE:EGAT:HOLD 100us
Characteristics
*RST value: 0s
SCPI: device–specific
Mode
A, BT
[SENSe<1|2>:]SWEep:EGATe:LENGth
In case of edge triggering, this command determines the time interval during which the
instrument sweeps.
The numeric suffixes <1|2> are not relevant.
Parameter
0 to 100 s
Example
SWE:EGAT:LENG 10ms
Characteristics
*RST value: 0s
SCPI: device–specific
Mode
A, BT
[SENSe<1|2>:]SWEep:EGATe:POLarity
This command determines the polarity of the external gate signal. The setting applies both to
the edge of an edge–triggered signal and the level of a level–triggered signal.
The numeric suffixes <1|2> are not relevant.
Parameter
POSitive | NEGative