Sinee EM500 - Count Value and Length Value Analog Output

EM500 Open-Loop Vector Control Inverter User Manual
304
running time, if (F12.17/18)
≥
the set accumulated running arrival time (F16.08),
inverter can not be used.
★ By setting this parameter, inverter may not be used normally. Please pay enough
attention
No.
Function
Range
Unit
Default
Type
F16.09
Factory
Password
0 - 65535
XXXXX
●
Factory Password
★
By setting this password, inverter may not be used normally. Please pay enough
attention
No.
Function
Range
Unit
Default
Type
F16.10
The percentage of
analog output
when the count
value of zero
0.00~100.00
%
0.00
〇
F16.11
The percentage of
analog output
when the count
value of
Designated Count
Value
0.00~100.00
%
100.00
〇
The analog output is set to count and length of the output of the offset Settings.
Figure 7-44 Count value and length value analog output
No.
Function
Range
Unit
Default
Type
F16.12
EC - A card slot
expansion card
type
0: No Expansion Card
1: Clock Card
2: Air compressor interface
Card
3: Phase sequence phase
0
〇