Sinee EM500 - 13.6 ILLUSTRATE

EM500 Open-Loop Vector Control Inverter User Manual
433
02H
Illegal data
address
The data address received by the slave (inverter) is not an
allowed address; in particular, the combination of the start
address and the transfer length of the register is invalid
03H
Illegal data
frame
The length of the data received by the slave (inverter) is not
correct
04H
Slave device
failure
An unrecoverable error occurred while attempting to
perform a requested operation on the slave (drive). Possible
cause A logical error or a write EEPROM failure
05H
Data out of
range
The data received by the slave (inverter) exceeds the
minimum to maximum range of the corresponding register
06H
Parameters
are
read-only
The current register is read-only and can not be written
07H
Parameters
can not be
changed
during
operation
The inverter is running, the current register can not be
written to, if you need to operate, please stop
08H
Parameters
are
password
protected
The current register is password protected
13.6 Illustrate
1) The inverter is running forward
Identifiers
Control
Field
Date Field
Send
0x401
04
70 00
00 01
Response
0x47F
02
01 00