Sinee EM500 - 6.2 FUNCTION PARAMETER TABLE

EM500 Open-Loop Vector Control Inverter User Manual
78
6.2 Function Parameter Table
No.
Function
Range
Unit
Default
Type
F00
Basic Function Parameter Group
F00.00
Not Used
F00.01
Drive Control Mode
of Motor 1
0: V/F control (VVF)
1: Sensorless Vector Control (SVC)
0
〇
F00.02
Command Source
Options
0: Keypad Control (LOC/REM
indicator on)
1: Terminal Control (LOC/REM
indicator off)
2: Communication Control (LOC/REM
indicator flickers)
0
〇
F00.03
Terminal Control
Mode Options
0: Terminal RUN for running,
Forward/Reverse (F/R)
1: Terminal RUN for forward, F/R
reverse
2: Terminal RUN for forward, Xi stop,
F/R reverse
3: Terminal RUN for running, Xi stop
Forward/Reverse (F/R)
0
〇
F00.04
Main Frequency
Source A Options
0: Numeric Frequency Setting F00.07
1: AI1
2: AI2
3: AI3
4: AI4 (Expansion Card)
5: High-Frequency Pulse Input (X7)
6: Main Frequency Communication
Percentage Setting
7: Main Frequency Communication
Direct Setting
8:digital Potentiometer
0
〇
F00.05
Auxiliary Frequency
Source B Options
0: Numeric Frequency Setting F00.07
1: AI1
2: AI2
3: AI3
4: AI4 (Expansion Card)
5: High-Frequency Pulse Input (X7)
6: Auxiliary Frequency Communication
Setting
7: Auxiliary Frequency Communication
0
〇