Sinee EM500 - 6. FUNCTION CODE TABLE; 6.1 PARAMETER DESCRIPTION

EM500 Open-Loop Vector Control Inverter User Manual
76
6. Function Code Table
6.1 Parameter Description
EM500 inverter has 24 groups of function codes as shown in Table 6–1, each group
having multiple function codes. F18 is a monitoring parameter group and used for
viewing inverter status; F19 is a fault record group and used for viewing three latest faults;
other groups are parameter setting groups and used for setting different functions.
Table 6–1 Introduction of Parameters
★
Note: If some parameters of EM500 are not used, 0 is returned after read; if user
retains some options of some parameters, these options can be set, but may result in
abnormal running of inverter. Please prevent incorrect operation of these parameters.
The table below describes all items of the function code table:
No.
F00.00 - F99.99: Numbering of function codes
Function
Complete names of function codes. “Not Used” means that this function code
will be retained temporarily, without actual meaning.
Range
Brief Parameter Description.
F00
Basic Function Parameter Group
F01
Motor 1 Parameter
F02
Input Terminal Function Group
F03
Output Terminal Function Group
F04
Start/Stop Control Parameter Group
F05
V/F Control Parameter Group
F06
Vector Control Parameter Group
F07
Protection Function Setting Group
F08
Preset Speed and Simple PLC
F09
PID Function Group
F10
Communication Function Group
F11
User-Defined Parameter Group
F12
Keypad and Display Function Group
F13
Torque Control Parameter Group
F14
Motor 2 Parameter Group
F15
Auxiliary Function Group
F16
Customized Function Group
F17
Virtual I/O Function Group
F18
Monitoring Parameter Group
F19
Fault Record Group
F25
Application of water supply basic groups
F26
Application of water supply advanced group
F27
Winding Applications Parameter Group
F28
Air compressor Applications Parameter Group