OnAir Digital Mixing Consoles
Conguration  6-59
Document generated: 10.10.14
SW V6.0
CR LSP Split enable    This mode enables the CR LSP signal to be split into left and right signal,
depending on the HP Split Mode in a similar way as for the headphone.
ST1 LSP Split enable    This mode enables the ST1 LSP signal to be split into left and right signal,
depending on the HP Split Mode in a similar way as for the headphone.
OnAir 1500/2500: Studio 1 not supported.
CR / ST1 HP/LSP  Split: Monitoring on left channel
Either the monitor signal is on the left HP/LSP channel, and the PFL signal
on the right one (Yes), or vice versa (No).
OnAir 1500/2500: Studio 1 not supported.
 CR / ST1 HP Split: Monitor Gain Headphones monitor signal gain setting in split mode. Range: –89.9 to
+12dB,orMute.
OnAir 1500/2500: Studio 1 not supported.
CR / ST1 HP Split: PFL Gain HeadphonesPFLsignalgainsettinginsplitmode.Range:–89.9to+12dB,
or Mute.
OnAir 1500/2500: Studio 1 not supported.
CR / ST1 PFL to SP SRC Routes the CR or Studio 1 PFL signal to the PFL/TB speaker. Settings: Yes/
No.
OnAir 1500/2500: Studio 1 not supported.
CR / ST1 Monitoring Mode Selects Mode I (Normal) or Mode II (Nearfield). Mode II (Nearfield) con-
verts the CR/Studio 1 DJ headphones output to a nearfield speakers output
(refer to the block diagrams below).
OnAir 1500: Monitoring Mode II not supported.
OnAir 3000: Monitoring Mode II supported for configurations C3-C6, and only for
Compact SCore systems.
To Next Page
Loading...
Need help?
General
