Studer OnAir 3000 - Page 372

OnAir Digital Mixing Consoles
Conguration 6-131
Document generated: 10.10.14
SW V6.0
Function Assignable to: Details
Rel.
in
SW
Key Group Key Unit LED Display Display Module Rotary Unit
MonSurLSPCut_Right V5.0 ● switch on/off the corresponding LSP, illuminate if off
MonSurLSPCut_RightSur V5.0 ● switch on/off the corresponding LSP, illuminate if off
MonSurModeDirect V2.2 ●
MonSurModeStereo V2.2 ●
MPX functions
MPX_CR_OnOff V2.2 ●
MPX_CR_Selection V2.2 ●
to dene the MPX conguration with the StripSelect func-
tion, this temporarily invalidates the common interaction
of StripSelect and UserGUI
MPX_ST1_OnOff V2.2 ●
MPX_ST1_Selection V2.2 ● see MPX_CR_Selection
VoiceMix functions
VoiceMix1...4_On/Off V6.0 ●
Snapshot & PartialOutputRouting functions
Snapshot_SLATE V2.0 ●
a key with the Snapshot_SLATE function is required to
recall a snapshot by a desk snapshot key, both keys has
to be pressed simultaneously
Snapshot_CREATE V4.0 ●
a key with the Snapshot_CREATE function is required to
create a snapshot by a desk snapshot key, both keys has
to be pressed simultaneously
Snapshot1-80 V2.0 ● recalls the corresponding snapshot
DeneStripFilter V2.2 ●
to dene a snapshot strip lter, this temporarily invalidate
the common interaction of StripSelect and UserGUI
PartialOutputRoutingKey1-1024 V2.2 ● recall the corresponding partial output routing
PartialOutputRoutingEnableKey V3.1 ● set the enable option of the modules desk group
Signaling functions
OnAir V1.0 ● LED function
OnAirPGMA V2.0 ● LED function
OnAirPGMB V2.0 ● LED function
OnAirREC V2.0 ● LED function
RedLight_CR V1.0 ● LED function
RedLight_ST1-3 V1.0 ● LED function
Next functions
StartNextA V2.0 ●
StartNextB V2.0 ●
TalkBack functions
TBActiveFrom_CR V2.0 ● reset TB from CR function, shows if TB fromCR is active
TBActiveFrom_Extern V2.0 ●
reset TB from Extern function, shows if TB fromExtern is
active
TBActiveFrom_ST1-3 V2.0 ● reset TB from ST function, shows if TB fromST is active
TBCRMicSelector V1.0 ●
assign to a KeyGroup, use dummy Keys (not existing
element no) for not used TB CRMics: Key 0=CRMic1,
1=CRMic2, 2=CRMic3, 3=CRMic4
TBKey1-20 V1.0 ●
for possible TB destinations see chapter ‚TB Destination
Key‘ of: OA3000 Implementation Notes Input Output
Selections.doc