5-1
IM 701210-05E
Horizontal and Vertical Axes
5
Chapter 5 Horizontal and Vertical Axes
5.1 Turning Channels ON/OFF
Procedure
MEASURE
CURSOR RESET SELECT
CH
ALL CH
MODE
POSITION
SIMPLE/ENHANCED
ACQ
START/STOP
SETUP DISPLAY
ZOOM
DUAL
CAPTURE
HISTORY
MATH
1
CH
2
CH
3
CH
4
CH
5
CH
6
CH
7
CH
8
CH
9
CH
10
CH
11
CH
12
CH
13
CH
14
CH
15
CH
16
DELAY
MANUAL TRIG
V/DIV TIME/DIV
TRIGGER
TRIG D
VERTICAL
HORIZONTAL
CAL
X-Y
SEARCH
7
DSP 1
8 9
DSP 2
654
1
0
23
ENTER
m
DSP 6DSP 5
LOGIC A
LOGIC B
EVENT
DSP 3 DSP 4
EXP
GO/NO-GO
ACTION
FILE
SHIFT
1. Press a key from CH1 to CH16 keys to select the desired channel.
To select a logic waveform, press SHIFT+CH9 (LOGIC A) or SHIFT+CH10
(LOGIC B).
To select an event waveform, press SHIFT+CH11 (EVENT).
To select a DSP channel (optional), press SHIFT + CH1 (DSP1) through SHIFT
+ CH6 (DSP6).
2. Press the Display soft key to select ON or OFF. You can also turn ON/OFF the
channel by pressing CH1 to CH16 twice.
Explanation
Input waveforms of CH1 to CH16, LOGIC A, and LOGIC B, DSP1 to DSP6 (optional),
and event waveforms can be displayed simultaneously.
For channels (CH1 to CH6) that are turned ON, the LED above the key illuminates.
Note
• The screen can be split into up to eight display areas using the DISPLAY menu (section
8.1). Scale values (section 8.9) and waveform labels (section 8.10) can also be displayed.
• If waveforms are loaded from the history memory or from a storage medium such as a
floppy disk, Zip disk, or PC card, the input waveform cannot be displayed. To compare
waveforms, use the snapshot function.
• Channels that do not have input modules installed cannot be turned ON.
•A waveform icon is displayed to the left of the title of the CH1 to CH16, DSP1 to DSP6,
LOGIC A/B, and EVENT setup menus. The icon color is set to the color of each waveform
(see section 17.4). The icon shape varies depending on the displayed setup menu as
follows:
CH1 to CH16 DSP1 to DSP6 LOGIC A/B EVENT
Setup menu title
Waveform icon
To Next Page
Loading...
