YOKOGAWA DL750 - Switching the Screen Display Font Size

17-2
IM 701210-06E
17.2 Switching the Screen Display Font Size
Procedure
MEASURE CURSOR RESET SELECT
CH
ALL CH
MODE POSITION
SIMPLE/ENHANCED
ACQ START/STOP
SETUP DISPLAY
ZOOM
DUAL
CAPTURE
HISTORY MATH
1
CH
2
CH
3
CH
4
CH
5
CH
6
CH
7
CH
8
CH
9
CH
10
CH
11
CH
12
CH
13
CH
14
CH
15
CH
16
DELAY
MANUAL TRIG
V/DIV TIME/DIV
TRIGGER
TRIG D
VERTICAL
HORIZONTAL
CAL X-Y
SEARCH
7
DSP 1
8 9
DSP 2
654
1
0
23
ENTER
m
DSP 6DSP 5
LOGIC A LOGIC B EVENT
DSP 3 DSP 4
EXP
GO/NO-GO
ACTION
FILE SHIFT
FILE SHIFT HELP MISC NUM KEY
1. Press MISC.
2. Press the System Config soft key.
3. Press the Scale Font soft key to select Small or Large.
If Large is selected, the waveform labels displayed at the upper left of the
waveform display area, the scale values of the vertical axis, and the trace labels
(waveform labels) are shown using a large font.
Waveform
display area
Trace Label
(Waveform label)
Scale values of the
vertical axis
Waveform label
Trace Label
(Waveform label)
Scale values of the
vertical axis
Waveform label
Waveform display area
The font size in the area enclosed by changes.
Scale values of the vertical axis
Scale values of the vertical axis
When Scale Font is set to Small
When Scale Font is set to Large
Explanation
The screen display font size can be set to small or large. The default setting is Small.
The font size changes for the waveform labels displayed at the upper left of the
waveform display area, the scale values of the vertical axis, and the trace labels
(waveform labels). If Large is selected and there are numerous waveforms displayed on
the screen, the scale values of the vertical axis may overlap.