YOKOGAWA DL750 User Manual

5-38
IM 701210-05E
5.18 Setting the Acceleration Measurement
<For a description of this function, refer to page 2-15.>
CAUTION
Before connecting the acceleration sensor, check that the bias current to the
sensor is OFF (see step 8 below). Otherwise, damage to the internal circuitry of
the acceleration sensors may result.
Procedure
MEASURE CURSOR RESET SELECT
CH
ALL CH
MODE POSITION
SIMPLE/ENHANCED
ACQ START/STOP
SETUP DISPLAY
ZOOM
DUAL
CAPTURE
HISTORY MATH
1
CH
2
CH
3
CH
4
CH
5
CH
6
CH
7
CH
8
CH
9
CH
10
CH
11
CH
12
CH
13
CH
14
CH
15
CH
16
DELAY
MANUAL TRIG
V/DIV TIME/DIV
TRIGGER
TRIG D
VERTICAL
HORIZONTAL
CAL X-Y
SEARCH
7
DSP 1
8 9
DSP 2
654
1
0
23
ENTER
m
DSP 6DSP 5
LOGIC A LOGIC B EVENT
DSP 3 DSP 4
EXP
GO/NO-GO
ACTION
FILE SHIFT
1. Press one of the keys from CH1 to CH16 to select the desired channel (select a
channel with the 701275(ACCL/VOLT) installed).
2. Press the Coupling soft key followed by the ACCL soft key.
Setting the Gain
3. Press the Gain soft key and select a value in the range of ×0.1 to ×100.
Setting the Sensitivity
4. Press the Next 1/2 soft key.
5. Press the Sensitivity soft key.
6. Turn the jog shuttle and set the sensitivity of the acceleration sensor in the
range of 0.10 mV/Unit to 2000.00 mV/Unit.
Setting the Unit
The default value is m/s
2
. Change the unit as necessary.
7. Press the Unit soft key to display a software keyboard, and enter the unit
according to the procedure given in section 4.2.
Connecting the Acceleration Sensor
8. Press the Bias soft key to select OFF.
9. Connect the acceleration sensor according to the procedures given in section 3.12.
Setting the Bias Current Supply
10. Press the Bias soft key to select ON.

YOKOGAWA DL750 Specifications

General

Brand	YOKOGAWA
Model	DL750
Category	Measuring Instruments
Language	English