16-14
IM 701210-06E
16.5 Sending Periodic Mail or Action Mail (SMTP
Client Function
<For a description of this function, refer to page 2-60.>
Procedure
Sending Periodic E-mail Messages
MEASURE
CURSOR RESET SELECT
CH
ALL CH
MODE
POSITION
SIMPLE/ENHANCED
ACQ
START/STOP
SETUP DISPLAY
ZOOM
DUAL
CAPTURE
HISTORY
MATH
1
CH
2
CH
3
CH
4
CH
5
CH
6
CH
7
CH
8
CH
9
CH
10
CH
11
CH
12
CH
13
CH
14
CH
15
CH
16
DELAY
MANUAL TRIG
V/DIV TIME/DIV
TRIGGER
TRIG D
VERTICAL
HORIZONTAL
CAL
X-Y
SEARCH
7
DSP 1
8 9
DSP 2
654
1
0
23
ENTER
m
DSP 6DSP 5
LOGIC A
LOGIC B
EVENT
DSP 3 DSP 4
EXP
GO/NO-GO
ACTION
FILE
SHIFT
FILE
SHIFT
HELP
MISC
NUM KEY
1. Press MISC.
2. Press the Network soft key.
3. Press the Mail Setup soft key. The Mail setup menu appears.
Setting the Mail Server
4. Use the jog shuttle and SELECT to select Mail Server.
5. Enter the IP address of the mail server according to the procedure given in
section 4.2. If you are using DNS, you can specify the mail server by name.
Setting the Recipient Mail Address
6. Use the jog shuttle and SELECT to select Mail Address.
7. Enter the recipient mail address using up to 40 characters according to the
procedure given in section 4.2.
Setting a Comment
8. Use the jog shuttle and SELECT to select Comment.
9. As necessary, enter the comment using up to 30 characters according to the
procedure given in section 4.2.
Setting the Time When the Mail Is to Be Sent
10. Use the jog shuttle and SELECT to select the hour, minute, or second of
MailBaseTime
11. Enter the time when mail is to be sent according to the procedure given in
section 4.2.
Setting the Attached Image File
12. Use the jog shuttle and SELECT to select ON (attach image file) or OFF (do
not attach image file).
Setting the Interval for Sending Mail
13. Use the jog shuttle and SELECT to select Interval.
14. Select the interval for sending mail in the range of 1 h to 24 h according to the
procedure given in section 4.2.
Sending a Test Mail
15. Turn the jog shuttle to move the cursor to Mail Test.
To send a test mail to the specified recipient, press SELECT.
While mail transmission is in progress,
is indicated at the upper left corner
of the screen.
To Next Page
Loading...
Need help?
General
