6-45
IM 701210-05E
Triggering
6
6.18 Setting the Action-on-Trigger
<For a description of this function, refer to page 2-29.>
Procedure
MEASURE
CURSOR RESET SELECT
CH
ALL CH
MODE
POSITION
SIMPLE/ENHANCED
ACQ
START/STOP
SETUP DISPLAY
ZOOM
DUAL
CAPTURE
HISTORY
MATH
1
CH
2
CH
3
CH
4
CH
5
CH
6
CH
7
CH
8
CH
9
CH
10
CH
11
CH
12
CH
13
CH
14
CH
15
CH
16
DELAY
MANUAL TRIG
V/DIV TIME/DIV
TRIGGER
TRIG D
VERTICAL
HORIZONTAL
CAL
X-Y
SEARCH
7
DSP 1
8 9
DSP 2
654
1
0
23
ENTER
m
DSP 6DSP 5
LOGIC A
LOGIC B
EVENT
DSP 3 DSP 4
EXP
GO/NO-GO
ACTION
FILE
SHIFT
1. Press SHIFT+MODE. The ACTION menu appears.
Setting the Action
2. Press the Mode soft key. The Mode select menu appears.
3. Press the soft key corresponding to the desired mode: OFF, On Trigger, or On Stop.
4. Press the Action soft key. The Action setup menu appears.
5. Use the jog shuttle and SELECT to select action to be enabled. (You can
select multiple actions.)
6. If you selected Save to File in step 3, use the jog shuttle and SELECT to set
the file save format to Binary, ASCII, or Float. If you selected Send Mail, use
the jog shuttle and SELECT to set Mail Count.
Setting the Number of Actions
7. Press the Sequence soft key to select Single or Continuous.
8. Press the ACQ Count sof key.
9. Turn the jog shuttel to set the numeber of actions. Pressing RESET resets the
count Infinite.
Setting the Execution Mode of the Action-on-Trigger/Action-on-Stop at Power ON
10. Press MISC.
11. Press the Next 1/2 soft key.
12. Press the Others soft key.
13. Press the Action Mode(Power ON) soft key to select ON or OFF.
Executing the Action-on-Trigger/Action-on-Stop
14. Press START/STOP to start the waveform acquisition and execution the action-
on-trigger. While action-on-trigger or action-on-stop is in execution,
is
displayed at the upper left corner of the screen.
In addition, if the following action is specified, the following icon is displayed in
the upper left corner of the screen while the action is being executed.
Image/Save to File: Save destination medium (
FD, Zip disk, PC
card, SCSI device, internal HD, network drive,
or USB storage device.)
Send Mail:
Aborting the Action-on-Trigger/Action-on-Stop
15. Press START/STOP to stop the waveform acquisition and abort the action-on-
trigger or action on stop.
To Next Page
Loading...
Need help?
General
