8-21
IM 701210-05E
Display
8
8.12 Turning the Level Indicator and Numeric Value
Display ON/OFF
<For a description of this function, refer to page 2-38.>
Procedure
MEASURE
CURSOR RESET SELECT
CH
ALL CH
MODE
POSITION
SIMPLE/ENHANCED
ACQ
START/STOP
SETUP DISPLAY
ZOOM
DUAL
CAPTURE
HISTORY
MATH
1
CH
2
CH
3
CH
4
CH
5
CH
6
CH
7
CH
8
CH
9
CH
10
CH
11
CH
12
CH
13
CH
14
CH
15
CH
16
DELAY
MANUAL TRIG
V/DIV TIME/DIV
TRIGGER
TRIG D
VERTICAL
HORIZONTAL
CAL
X-Y
SEARCH
7
DSP 1
8 9
DSP 2
654
1
0
23
ENTER
m
DSP 6DSP 5
LOGIC A
LOGIC B
EVENT
DSP 3 DSP 4
EXP
GO/NO-GO
ACTION
FILE
SHIFT
1. Press DISPLAY.
2. Press the Next 1/2 soft key.
3. Press the Monitor soft key. The monitor selection menu appears.
4. Press the Level Indicator soft key to display the level indicator, the Numeric
Value soft key to display numeric values, the Both soft key to display both, or
the OFF soft key to display neither.
Explanation
Level Indicator and Numeric Values: Monitor
Level indicator: The level of each waveform is displayed using an indicator to the right
of the waveform display window.
Numeric value: Displays the measured value of each channel when in roll mode.
Numeric value
Level indicator
Note
• The numerical values are displayed when the time base is set to internal clock and the T/
div setting is set slower than 100 ms/div.
• The numerical values are not displayed during the GO/NO-GO determination.
To Next Page
Loading...
