YOKOGAWA DL750 User Manual

16-15
IM 701210-06E
Ethernet Interface (Optional)
16
16.5 Sending E-mail Messages (Periodic Mail or Action Mail)
Note
• For keyboard (soft keyboard) operation, see section 4.2, “Entering Values and Strings.”
• The sender (From) address of the e-mail messages sent by the DL750/DL750P is the
same as the specified recipient address.
• If the transmitted contents indicate error logs, the most recent error is at the top of the
error log.
• To use this function, configure the TCP/IP settings beforehand according to section 16.2,
“Setting up the TCP/IP.”
• If you set Interval to OFF, periodic mail is not sent.
Sending Action E-mail Messages
MEASURE CURSOR RESET SELECT
CH
ALL CH
MODE POSITION
SIMPLE/ENHANCED
ACQ START/STOP
SETUP DISPLAY
ZOOM
DUAL
CAPTURE
HISTORY MATH
1
CH
2
CH
3
CH
4
CH
5
CH
6
CH
7
CH
8
CH
9
CH
10
CH
11
CH
12
CH
13
CH
14
CH
15
CH
16
DELAY
MANUAL TRIG
V/DIV TIME/DIV
TRIGGER
TRIG D
VERTICAL
HORIZONTAL
CAL X-Y
SEARCH
7
DSP 1
8 9
DSP 2
654
1
0
23
ENTER
m
DSP 6DSP 5
LOGIC A LOGIC B EVENT
DSP 3 DSP 4
EXP
GO/NO-GO
ACTION
FILE SHIFT
FILE SHIFT HELP MISC NUM KEY
1. Set items according to steps 1 to 9 in “Sending Periodic E-mail Messages.”
You do not have to set MailBaseTime and Interval for action mail. If you wish to
use only action mail, set Interval to OFF.
Setting the Action
• From the ACTION Menu
2. Press SHIFT+MODE.
3. Press the Mode soft key to select ON Trigger.
4. Press the Action soft key. The action setup menu appears.
5. Use the jog shuttle and SELECT to set Send Mail to ON.
6. Use the jog shuttle and SELECT to set Mail Count (the number of mail
messages).
7. Press START/STOP to start the waveform acquisition. A mail is sent to the
specified address each time a trigger occurs.
While mail transmission is in progress,
is indicated at the upper left corner
of the screen.

YOKOGAWA DL750 Specifications

General

Brand	YOKOGAWA
Model	DL750
Category	Measuring Instruments
Language	English