16-16
IM 701210-06E
• From the GO/NO-GO Menu
2. Press SHIFT+MEASURE.
3. Press the Mode soft key. The Mode selection menu appears.
4. Press the Zone or Parameter soft key.
5. Set GO/NO-GO items according to the procedure in section 11.8 and 11.9.
6. Press the Action soft key. The action setup menu appears.
7. Use the jog shuttle and SELECT to set Send Mail to ON.
8. Use the jog shuttle and SELECT to set Mail Count (the number of mail
messages).
9. Press the Exec soft key to start the GO/NO-GO operation. When a specified
condition occurs, a mail is sent to the specified address.
While mail transmission is in progress,
is indicated at the upper left corner
of the screen.
Note
• The mail recipient is the address specified in “Mail Address” of “Network”/“Mail Setup” in
the MISC menu.
• The sender (From) address of the e-mail messages sent by the DL750/DL750P is the
same as the specified recipient address.
• Periodic mail and action mail can be used together. To use only action mail, set Interval to
OFF.
• To use this function, configure the TCP/IP settings beforehand according to section 16.2,
“Setting up the TCP/IP.”
16.5 Sending E-mail Messages (Periodic Mail or Action Mail)
To Next Page
Loading...
Need help?
General
