16-17
IM 701210-06E
Ethernet Interface (Optional)
16
Explanation
Mail Server
Specify the IP address of the network mail server. On networks supporting DNS, you
can specify the host and domain by name instead of the IP address.
Mail Address
Enter the recipient address using up to 40 characters.
Comment
The comment is written on the first line of the transmitted mail. Enter it as necessary.
Enter comment using up to 30 characters.
Transmission Time: MailBaseTime
The time when mail transmission is to start can be set in units of hour, minute, and
second, in the following range.
0:0:0 to 23:59:59
Attaching Image Data (Attached Image File, Version 4.01 or Later)
The screen image shown at the time of mail transmission can be attached to the mail.
The data format of the screen image data is the format specified in section 13.11,
“Saving Screen Image Data.”
The file name differs between periodic mail and action mail.
File name of periodic mail: DL_image.png
File name of action mail: DL_nnnn.png (where nnnn is an automatically
assigned number in the range of 0001 to 1000)
Transmission Interval
The following mail transmission intervals are available.
OFF, 1 H, 2 H, 3 H, 4 H, 6 H, 8 H, 12 H, and 24 H
However, if you select OFF, periodic mails cannot be transmitted.
Sending a Test Mail: Mail Test
A test mail is sent to the address specified by Mail Address.
16.5 Sending E-mail Messages (Periodic Mail or Action Mail)
To Next Page
Loading...
Need help?
General
