5-29
IM 701210-05E
Horizontal and Vertical Axes
5
5.16 Setting the Temperature Measurement
<For a description of this function, refer to page 2-13.>
Procedure
MEASURE
CURSOR RESET SELECT
CH
ALL CH
MODE
POSITION
SIMPLE/ENHANCED
ACQ
START/STOP
SETUP DISPLAY
ZOOM
DUAL
CAPTURE
HISTORY
MATH
1
CH
2
CH
3
CH
4
CH
5
CH
6
CH
7
CH
8
CH
9
CH
10
CH
11
CH
12
CH
13
CH
14
CH
15
CH
16
DELAY
MANUAL TRIG
V/DIV TIME/DIV
TRIGGER
TRIG D
VERTICAL
HORIZONTAL
CAL
X-Y
SEARCH
7
DSP 1
8 9
DSP 2
654
1
0
23
ENTER
m
DSP 6DSP 5
LOGIC A
LOGIC B
EVENT
DSP 3 DSP 4
EXP
GO/NO-GO
ACTION
FILE
SHIFT
1. Press a key from CH1 to CH16 keys to select the desired channel (select a
channel with the 701261 (UNIVERSAL)/701262 (UNIVERSAL (AAF))/701265
(TEMP/HPV) installed).
2. Press the Coupling soft key followed by the TC soft key.
Selecting the Thermocouple Type
3. Press the Type soft key to select the thermocouple from K to Au7Fe.
Setting the Display Range
4. Press the Upper soft key.
5. Turn the jog shuttle to set the upper limit.
6. Likewise, set Lower.
Selecting the Temperature Unit
7. Press the Next 1/2 soft key.
8. Press the Unit soft key to select °C, K, or °F.
Setting the RJC
9. Press the RJC soft key to select OFF or ON.
Setting Burnout
10. Press the Burn Out soft key to select OFF or ON.
AC is not available on the 701265.
To Next Page
Loading...
