9-15
IM 701210-05E
Recording in Recorder Mode (Realtime Recording) (Only on the DL750P)
9
Setting the Trigger Mode
8. Press MODE.
9. Press the soft key corresponding to the desired mode to set the trigger mode to
Auto or Log.
Setting the Acquisition Mode
Normally, the acquisition mode in Chart Recorder mode is envelope. If you wish to
switch to normal mode, carry out steps 10 to 13 below.
10. Press MISC.
11. Press the Next 1/2 soft key
12. Press the Others soft key.
13. Press the Chart Recorder Sample soft key to set the acquisition mode in Chart
Recorder mode to Envelope or Normal.
Set the trigger mode Set the acquisition mode
Starting/Stopping the Numeric Value Recording
14. Press START/STOP. The waveform acquisition starts, and chart recording with
numeric values also starts.
15. To stop chart recording with numeric values, press START/STOP again. The
waveform acquisition stops, and chart recording with numeric values also stops.
Explanation
Output Device
To record numeric values on the built-in printer, select Chart. To save numeric values to
a file on a specified storage medium, select File.
Output Interval: Interval
Select 1 s, 2 s, 5 s, 10 s, 15 s, 20 s, 30 s, 1 min, 2 min, 5 min, 10 min, 15 min, 20 min, 30
min, or 60 min.
Print Direction: Direction
If the output destination is set to Chart, set the print direction to Normal (the newest data
is at the top of the paper) or Rotation (the oldest data is at the top of the paper).
Output File: File Setup
If the output destination is set to File, set the output file (auto naming, file name, and file
output destination). These settings are the same as those of normal files. For details,
see section 13.7.
9.6 Recording Numeric Values
To Next Page
Loading...
Need help?
General
