YOKOGAWA DL750 User Manual

13-69
IM 701210-06E
Saving and Loading Data
13
• Drive Letter
If the PC to which the DL750/DL750P is connected has multiple hard disks or if the
hard disk is partitioned, connecting the DL750/DL750P will cause the internal hard
disk of the DL750/DL750P to be assigned drive letters after the hard disks on the PC.
For details, see the instruction manual for the PC or the drive.
The drive letter for the DL750/DL750P cannot be changed.
Example
• The PC uses one hard disk as a single drive
Before connection C: (HDD)
After connection C: (HDD)
D: (DL750/DL750P)
• The PC uses one hard disk as two drives
Before connection C: (HDD)
D: (HDD)
After connection C: (HDD)
D: (HDD)
E: (DL750/DL750P)
Actually, this may vary depending on how the hard disk is partitioned and the type of
interface (IDE, SCSI, etc) and drive.
Note
• The internal hard disk of the DL750/DL750P has a built-in terminator. When the DL750/
DL750P is connected to a PC, it is recommended that the DL750/DL750P be connected to
the end of the SCSI chain.
• Note that the driver letter assignments are different from the DL708, DL708E, and DL716.
• Do not access the internal hard disk of the DL750/DL750P from the PC when the internal
hard disk is being accessed from the DL750/DL750P. Likewise, do not access the internal
hard disk from the DL750/DL750P when the internal hard disk is being accessed from the
PC.
13.18 Connecting a PC to the DL750 via SCSI

YOKOGAWA DL750 Specifications

General

Brand	YOKOGAWA
Model	DL750
Category	Measuring Instruments
Language	English