To Next Page

To Previous Page

16-4

IM 701210-06E

16.2 Setting up the TCP/IP

Setting the DNS

8. Use the jog shuttle and SELECT to set DNS to ON, OFF, or AUTO. (AUTO

can be specified when DHCP is ON.)

When DNS is set to AUTO, the domain name and DNS server name are

automatically configured by power-cycling the DL750/DL750P.

If DNS is set to ON, the domain name, DNS server name, and domain suffix are

displayed.

If DNS is set to OFF, check the network cable connection and power cycle the

DL750/DL750P.

Setting the Domain Name

9. Use the jog shuttle and SELECT to select Domain Name.

10. Enter the domain name according to the procedure given in section 4.2.

Setting the DNS Server

11. Use the jog shuttle and SELECT to set DNS Server1 (primary DNS server).

Enter using values in the range of 0 to 255.

12. Likewise, set the secondary DNS server in DNS Server2.

Setting the Domain Suffix

13. Use the jog shuttle and SELECT to set Domain Suffix1 (primary domain suffix).

14. Likewise, set the secondary domain suffix in Domain Suffix2.

Note

For keyboard (soft keyboard) operation, see section 4.2, “Entering Values and Strings.”

Turning ON/OFF the Power

15. To apply the new settings, the DL750/DL750P must be power cycled.

After all the settings are complete, turn the power to the DL750/DL750P OFF,

then back ON again.

YOKOGAWA DL750 User Manual

Questions and Answers: