16-49
IM 701210-06E
Ethernet Interface (Optional)
16
Explanation
Set the time difference from GMT (Greenwich Mean Time). Make sure to set this value if
you are using the Web server function.
Setting the Time Difference from GMT (Greenwich Mean Time)
Set the time difference in the range of –12 hour 00 minute to 13 hour 00 minute.
For example, Japan standard time is ahead of GMT by 9 hours. In this case, set Time
Hour to 9 and Minute to 00.
Checking the Standard Time
Check the standard time for the region where the DL750/DL750P is to be used using one
of the following methods.
• Check the date and time settings on your PC.
• Check the site at the following
URL:http://www.worldtimeserver.com/
Note
The DL750/DL750P does not support daylight savings time. To set the daylight savings time,
adjust the time difference from GMT.
Setting the SNTP
When turning ON the power to the instrument, the instrument’s time is synchronized with
that of the SNTP server connected to the network.
Note
• If a time difference from world standard time (Greenwich Mean Time) is specified, the time
obtained from the SNTP server is adjusted accordingly, and that time is used.
• When setting the date and time on the instrument, you can synchronize the time with the
SNTP server. For details, see section 3.5, “Setting the Date and Time.”
• When not synchronizing the time with the SNTP server, do not enter the SNTP server’s IP
address.
16.8 Setting the Time Difference from GMT (Greenwich Mean Time)/SNTP
To Next Page
Loading...
Need help?
General
