List of Figures
20
14207L-001 A ZM400/ZM600 Maintenance Manual 8/9/07
Figure 229 • Remove the Electronics Cover ....................................................................................370
Figure 230 • Slide the Platen Roller Assembly ................................................................................371
Figure 231 • Remove the Platen Roller Assembly ...........................................................................372
Figure 232 • Remove the Drive Belt ................................................................................................373
Figure 233 • Remove the Platen Pulley ...........................................................................................374
Figure 234 • Remove the E-ring and Washer ..................................................................................375
Figure 235 • Push the Drive Shaft Through .....................................................................................376
Figure 236 • Remove the Roller Bearings .......................................................................................376
Figure 237 • Align Flat Spots on the Shaft .......................................................................................377
Figure 238 • Locate the Upper and Lower Flanges .........................................................................378
Figure 239 • Bearing Keys ...............................................................................................................379
Figure 240 • Align the Drive Pin and Drive Shaft .............................................................................380
Figure 241 • Install the Platen Roller Assembly ...............................................................................381
Figure 242 • Removing and Installing E-rings and Bearings ...........................................................383
Figure 243 • Rear View of Peel Assembly .......................................................................................384
Figure 244 • Installing Peel Roller Assembly ...................................................................................385
Figure 245 • Locate the Electronics Cover Mounting Screw ............................................................389
Figure 246 • Remove the Electronics Cover Mounting Screws .......................................................390
Figure 247 • Remove the Electronics Cover ....................................................................................390
Figure 248 • Locate the Cable Clip ..................................................................................................391
Figure 249 • Remove the Control Panel ..........................................................................................392
Figure 250 • Locate the Upper and Lower Flanges .........................................................................393
Figure 251 • Locate the Electronics Cover Mounting Screw ............................................................395
Figure 252 • Remove the Electronics Cover Mounting Screws .......................................................396
Figure 253 • Remove the Electronics Cover ....................................................................................396
Figure 254 • Remove the Radio Card ..............................................................................................397
Figure 255 • Remove the Wireless Board ........................................................................................398
Figure 256 • Remove the Wireless Board Mounting Standoffs ........................................................399
Figure 257 • Remove the Wired Ethernet Board .............................................................................400
Figure 258 • Remove the Wired Ethernet Board Standoffs .............................................................400
Figure 259 • Main Logic Board Assembly Connection Locations ....................................................401
Figure 260 • Remove the Old MLB ..................................................................................................402
Figure 261 • Locate the Upper and Lower Flanges .........................................................................404
Figure 262 • Configuration Label .....................................................................................................405
Figure 263 • Locate the Electronics Cover Mounting Screw ............................................................406
Figure 264 • Remove the Electronics Cover Mounting Screws .......................................................407
Figure 265 • Remove the Electronics Cover ....................................................................................407
Figure 266 • Remove the Radio Card ..............................................................................................408
Figure 267 • Remove the Wireless Board ........................................................................................
409
Figure 268 • Remove the Blank Cover ............................................................................................410
Figure 269 • Install the Standoffs .....................................................................................................411
Figure 270 • Install the Wireless Board ............................................................................................412
Figure 271 • Locate the Upper and Lower Flanges .........................................................................413
Figure 272 • Locate the Electronics Cover Mounting Screw ............................................................415
Figure 273 • Remove the Electronics Cover Mounting Screws .......................................................416
Figure 274 • Remove the Electronics Cover ....................................................................................416
Figure 275 • Remove the Ethernet Board ........................................................................................417
Figure 276 • Remove the Blank Cover and Screw ..........................................................................418
Figure 277 • Clean the J4 Pads .......................................................................................................418
Figure 278 • Install the Mounting Standoffs .....................................................................................419
Figure 279 • Locate the Upper and Lower Flanges .........................................................................420
Figure 280 • Locate the Electronics Cover Mounting Screw ............................................................423
To Next Page
Loading...
Need help?
General
