Zebra ZM400 Series

21
List of Figures
8/9/07 ZM400/ZM600 Maintenance Manual 14207L-001 A
Figure 281 • Remove the Electronics Cover Mounting Screws .......................................................424
Figure 282 • Remove the Electronics Cover ....................................................................................424
Figure 283 • Locate the Upper and Lower Flanges .........................................................................425
Figure 284 • Media Door ..................................................................................................................427
Figure 285 • Remove the Old Window .............................................................................................429
Figure 286 • Align the New Window ................................................................................................430
Figure 287 • Position Tab ................................................................................................................431
Figure 288 • Remove the Old Lower Front Panel ............................................................................432
Figure 289 • Hook the Lower Tabs ..................................................................................................433
Figure 290 • Snap to the Mounting Hooks .......................................................................................434
Figure 291 • Remove and Install the Rear End-Cap ........................................................................435
5 • Drawings and Parts
Figure A • Outer Casings .................................................................................................................440
Figure B • Media Door .....................................................................................................................442
Figure C • Rear End Cap .................................................................................................................443
Figure D • Media and Ribbon Path ..................................................................................................444
Figure E • Media Hanger .................................................................................................................446
Figure F • Media Sensors ................................................................................................................447
Figure G • Ribbon Supply Spindle ...................................................................................................448
Figure H • Print Mechanism View 1 .................................................................................................449
Figure I • Print Mechanism View 2 ...................................................................................................450
Figure J • Printhead Conversion ......................................................................................................451
Figure K • Platen Housing ................................................................................................................452
Figure L • Static Brush .....................................................................................................................454
Figure M • Ribbon Take-up Spindle .................................................................................................455
Figure N • Drive System Components .............................................................................................456
Figure O • Electronic Components ..................................................................................................457
Figure P • Main Logic Board ............................................................................................................458
Figure Q • Wireless Board ...............................................................................................................459
Figure R • Wired Ethernet Board/Internal PrintServer .....................................................................460
Figure S • Available Media Handling Options ..................................................................................462
Figure T • Cutter Option ...................................................................................................................464
Figure U • Peel and Rewind Option .................................................................................................465
Figure V • Liner Take-up Option ......................................................................................................466
Figure W • Inside Coated Ribbon Supply Spindle ...........................................................................467