Zebra ZM400 Series User Manual

19
List of Figures
8/9/07 ZM400/ZM600 Maintenance Manual 14207L-001 A
Figure 177 • Spindle Installation ......................................................................................................313
Figure 178 • Locate the Upper and Lower Flanges .........................................................................315
Figure 179 • Remove and Install the Hanger Assembly ..................................................................317
Figure 180 • Remove the Front Cover .............................................................................................318
Figure 181 • Remove and Install the Tear-Off Bar ...........................................................................319
Figure 182 • Install the New Tear-Off Bar ........................................................................................320
Figure 183 • Locate the Pems .........................................................................................................320
Figure 184 • Kit Contents .................................................................................................................321
Figure 185 • Kit Contents .................................................................................................................322
Figure 186 • Remove and Install the Static Brush Assembly) .........................................................324
Figure 187 • Locate the Electronics Cover Mounting Screw ............................................................326
Figure 188 • Remove the Electronics Cover Mounting Screws .......................................................327
Figure 189 • Remove the Electronics Cover ....................................................................................327
Figure 190 • Remove the Front Cover .............................................................................................328
Figure 191 • Locate and Position the Mounting Brackets ................................................................329
Figure 192 • Install the Cutter Assembly ..........................................................................................330
Figure 193 • Cutter Shield and Catch Tray ......................................................................................331
Figure 194 • Locate Cutter Connector on the Main Logic Board .....................................................332
Figure 195 • Locate the Upper and Lower Flanges .........................................................................333
Figure 196 • Remove Old Peel Assembly ........................................................................................334
Figure 197 • Install Peel Assembly ..................................................................................................335
Figure 198 • Rear View of Peel Assembly .......................................................................................336
Figure 199 • Locate the Electronics Cover Mounting Screw ............................................................338
Figure 200 • Remove the Electronics Cover Mounting Screws .......................................................339
Figure 201 • Remove the Electronics Cover ....................................................................................339
Figure 202 • Remove the Front Cover .............................................................................................340
Figure 203 • Remove the Old Base .................................................................................................341
Figure 204 • Install the Rewind Pan .................................................................................................342
Figure 205 • Install the Rewind Spindle Assembly ..........................................................................344
Figure 206 • Connect the Rewind Cable to the Main Logic Board ...................................................345
Figure 207 • Install the Motor and Spindle Assembly ......................................................................346
Figure 208 • Locate the Upper and Lower Flanges .........................................................................347
Figure 209 • Remove the Tear Bar ..................................................................................................348
Figure 210 • Remove the Peel Assembly ........................................................................................349
Figure 211 • Locate the Pems .........................................................................................................350
Figure 212 • Install the New Peel Assembly ....................................................................................351
Figure 213 • Load the Rewind Media ...............................................................................................353
Figure 214 • Load the Rewind Peel Media ......................................................................................353
Figure 215 • Align the Rewind Media ...............................................................................................354
Figure 216 • Remove the E-ring and Washers ................................................................................356
Figure 217 • Remove the Rewind Spindle .......................................................................................357
Figure 218 • Remove the Rewind Back Plate ..................................................................................357
Figure 219 • Remove the Spindle ....................................................................................................358
Figure 220 • Remove the Outer Rewind Guide ...............................................................................358
Figure 221 • Align the Outer Rewind Guide .....................................................................................359
Figure 222 • Slide the Platen Roller Assembly ................................................................................363
Figure 223 • Remove the Platen Roller Assembly ...........................................................................364
Figure 224 • Bearing Keys ...............................................................................................................365
Figure 225 • Align the Drive Pin and Drive Shaft .............................................................................366
Figure 226 • Install the Platen Roller Assembly ...............................................................................367
Figure 227 • Locate the Electronics Cover Mounting Screw ............................................................369
Figure 228 • Remove the Electronics Cover Mounting Screws .......................................................370

Zebra ZM400 Series Specifications

General

Brand	Zebra
Model	ZM400 Series
Category	Label Maker
Language	English