Altera Corporation 12–23
September 2004 Stratix Device Handbook, Volume 2
Remote System Configuration with Stratix & Stratix GX Devices
3. Select the enhanced configuration device used (EPC4, EPC8,
EPC16), and the mode used (1-bit Passive Serial or Fast Passive
Parallel). Only during the initial programming file generation can
you specify the Options, Configuration Device, or Mode settings.
While generating the partial programming file, all of these settings
are grayed out and inaccessible.
4. In the Input files to convert box, highlight SOF Data at Page 0 and
click Add File. Select input SOF file(s) for this configuration page
and insert them.
5. Repeat Step 4 for the Page 1 application configuration page.
6. Check the Memory Map File box to generate a memory map output
file that specifies the start/end addresses of each configuration page
and user data blocks.
7. Save the CPF setup (optionally), by selecting Save Conversion
Setup… and specifying a name for the .cof output file.
8. Click OK to generate initial programming and memory map files.
To Next Page
Loading...
