Altera Stratix - Revision History

Section VI–2 Altera Corporation
System Configuration & Upgrades Stratix Device Handbook, Volume 2
Revision History
The table below shows the revision history for Chapters 11 through 12.
Chapter Date/Version Changes Made
11 July 2005, v3.2 ● Updated “PORSEL Pins” and “nIO_PULLUP Pins” sections.
● Updated “FPP Configuration Using an Enhanced Configuration
Device” section.
● Updated “PPA Configuration” section.
September 2004, v3.1
● Corrected spelling error.
April 2004, v3.0
● In the “PORSEL Pins” section and the “nIO_PULLUP Pins” section,
several pull-down resistors were changed to pull-up resistors.
● Updated notes in Figure 11–3.
● Two vertical V
CC
lines removed in Figures 11–12 to 11–14.
● Three paragraphs added regarding the CONF_DONE and
INIT_DONE pins on page 13-18.
● Value in Note 1 changed in Tables 11–8 and 11–9.
● Deleted reference to AS in Table 11–15 because Stratix does not
support AS mode.
● Text added before callout of Figure 11–7.
July 2003, v2.0
● Updated Remote/local update PPA typical use description on page
11-1.
● Updated VCCSEL Pins section on page 11-3.
● Updated figures to use 10k resistors throughout for configuration
control signals.
● Updated text on page 11-23 to tell how to connect a microprocessor
to nSTATUS.
● Figure 11–19, Note 3.
● Updated Table 11–12.
● Added Note 6 to Figure 11–21 and the text below the figure describing
the
nCE pin.
● Updated definitions for CLKUSR, and JTAG pins in Table 11–16.
12 September 2004, v3.1
● Editorial corrections.
April 2004, v3.0
● The input file in Figure 12–22 was changed to
remote_update_initial_pgm.pdf.
● Title in Figure 12–23 was changed from Local... to Remote Update
Partial Programming File Generation.
● Rearranged the “Quartus II Software Support” section.
July 2003, v2.0
● Added altremote_update Megafunction section on pages 12-18 to 12-
21.