B. Braun Dialog+ - Repair Instructions

3. Repair Instructions 1/2010 3 - 1
BA-TE-DE08C M.KAY
Dialog+ SW9xx_sm_Chapter 3_1-2010.doc/pdf <100329> yymmdd
B. Braun Avitum AG
Dialog
+
SW 9.xx
Table of Contents Page
3. Self Test SW 9.xx
3-5
3.1 Microprocessor Unit MPU Test from Controller/Supervisor
3-5
3.2 Status Self Test in Service Overview
3-6
3.2.1 Set-Up Low Level Controller LLC Test Codes 3-7
3.2.2 Set-Up Low Level Supervisor LLS Test Codes 3-7
3.2.3 Example LLC/LLS Test Codes for Blood Leak Detector 3-8
3.2.4 Overview Test Codes 3-8
3.3 Self Tests in Preparation SW 9.XX Switch Mode Power
Supply Microcontroller SMPS-MC
3-9
3.3.1 Service Mode (DIR_ON) 3-9
3.3.2 Battery 3-9
3.3.3 EEPROM 3-10
3.3.4 Buzzer Test via LLS 3-10
3.3.5 Alarm System 3-11
3.3.6 Monitoring of Analog Voltage
±
12 V
3-12
3.3.7 Blood Leak Detector 3-12
3.3.8 DFS Pressure Test (Table) 3-13
3.3.8.1 DFS Pressure Test 3-16
3.3.8.2 Membrane Movement/Pressure Build-up VDABK 3-17
3.3.8.3 Pressure Reduction VDABK with UFP 3-18
3.3.8.4 VBP Test 3-19
3.3.8.5 VDE/VDA Test 3-20
3.3.8.6 Pressure Build-up VDABK 3-21
3.3.8.7 Pressure Reduction Membrane Test with UFP 3-22
3.3.8.8 Membrane Test 3-23
3.3.8.9 Pressure Build-up VABK 3-24
3.3.8.10 Membrane Movement to Inlet Side 3-25
3.3.8.11 Pressure Reduction VABK with UFP 3-26
3.3.8.12 VEBK Test 3-27
3.3.8.13 Pressure Reduction 3-28
3.3.9 Integrity Test HDF Online 3-29
3.3.10 UF Pump 3-31
3.3.11 Conductivity 3-32