Command Default
None
Command Modes
L2VPN pseudowire class configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
The following keywords were added:
•
preferred-path
•
sequencing
•
switching tlv
•
tag-rewrite
•
transport-mode
Release 3.9.0
The keyword redundancy one-way was introduced.Release 4.2.0
The keyword load-balancing flow-label was introduced.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
All L2VPN configurations can be deleted using the no l2vpn command.Note
Task ID
OperationsTask ID
read, writel2vpn
Examples
This example shows how to define MPLS pseudowire encapsulation:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# pw-class kanata01
RP/0/RSP0/CPU0:router(config-l2vpn-pwc)# encapsulation mpls
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
129
Point to Point Layer 2 Services Commands
pw-class encapsulation mpls
To Next Page
Loading...
Need help?
General
