Examples
The following sample output is from the show l2tp session brief command:
RP/0/RP00/CPU0:router(config-l2vpn-pw)# show l2tp session brief
Tue Jun 10 12:51:30.901 UTC
LocID TunID Peer-address State Username, Intf/sess/cir Vcid, Circuit
1606803058 1487464659 26.26.26.26 est,UP 101, Gi0/2/0/1.101
3663696887 1487464659 26.26.26.26 est,UP 100, Gi0/2/0/1.100
This table describes the significant fields shown in the display.
Table 1: show l2tp session brief Field Descriptions
DescriptionField
Local session ID.LocID
Local tunnel ID for this session.TunID
The IP address of the other end of the session.Peer-address
The state of the session.State
The Virtual Circuit ID of the session. This is the same
value of the pseudowire ID for l2vpn.
Vcid
The following sample output is from the show l2tp session detail command:
RP/0/RP00/CPU0:router(config-l2vpn-pw)# show l2tp session detail
Tue Jun 10 12:53:19.842 UTC
Session id 1606803058 is up, tunnel id 1487464659, logical session id 131097
Remote session id is 2602674409, remote tunnel id 2064960537
Remotely initiated session
Call serial number is 4117500017
Remote tunnel name is ASR9K-PE2
Internet address is 26.26.26.26:1248
Local tunnel name is PRABHRAM-PE1
Internet address is 25.25.25.25:4272
IP protocol 115
Session is L2TP signaled
Session state is established, time since change 00:07:28
UDP checksums are disabled
Session cookie information:
local cookie, size 4 bytes, value 6d 3e 03 67
remote cookie, size 4 bytes, value 0d ac 7a 3b
Tie breaker is 0xfee65781a2fa2cfd, enabled TRUE.
Sequencing is off
Conditional debugging is disabled
Unique ID is 101
Session Layer 2 circuit
Payload type is Ethernet, Name is GigabitEthernet0_2_0_1.101
Session vcid is 101
Circuit state is UP
Local circuit state is UP
Remote circuit state is UP
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
154
Point to Point Layer 2 Services Commands
show l2tp session
To Next Page
Loading...
Need help?
General
