Examples
The following example shows how both a syslog message and an SNMP trap are generated with the bridge
bar and learns more MAC addresses than the configured limit:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group 1
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bar
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# mac
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-mac)# limit
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-mac-limit)# notification both
Related Commands
DescriptionCommand
Configures bridge behavior when the number of learned MAC
addresses reaches the MAC limit configured.
action (VPLS), on page 232
Establishes a bridge domain, and enters L2VPN bridge group bridge
domain configuration mode.
bridge-domain (VPLS), on page 240
Creates a bridge group so that it can contain bridge domains and then
to assign network interfaces to the bridge domain.
bridge group (VPLS), on page 242
Enters L2VPN configuration mode.l2vpn, on page 100
Enters L2VPN bridge group bridge domain MAC configuration
mode.
mac (VPLS), on page 277
Configures the specified action when the number of MAC addresses
learned on a bridge is reached.
maximum (VPLS), on page 281
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
296
Multipoint Layer 2 Services Commands
notification (VPLS)
To Next Page
Loading...
Need help?
General
