MAC limit: 4294967295, Action: none, Notification: syslog
MAC limit reached: no
MAC port down flush: enabled
MAC Secure: disabled, Logging: disabled
Split Horizon Group: none
Dynamic ARP Inspection: disabled, Logging: disabled
IP Source Guard: disabled, Logging: disabled
DHCPv4 snooping: disabled
IGMP Snooping profile: none
Bridge MTU: 1500
MIB cvplsConfigIndex: 1
Filter MAC addresses:
Create time: 27/04/2011 10:00:47 (00:14:31 ago)
No status change since creation
ACs: 0 (0 up), VFIs: 1, PWs: 1 (1 up), PBBs: 0 (0 up)
List of ACs:
List of Access PWs:
List of VFIs:
VFI 1
P2MP:
RSVP-TE transport, BGP signaling, PTree ID 14
LSM-ID: 0xdeadbeef
PW: neighbor 110.110.110.110, PW ID 1234, state is up (established)
PW class not set, XC ID 0xfffc0001
Encapsulation MPLS, protocol LDP
Source address 100.100.100.100
PW type Ethernet, control word disabled, interworking none
PW backup disable delay 0 sec
Sequencing not set
PW Status TLV in use
MPLS Local Remote
Label 16000 16000
Group ID 0x0 0x0
Interface 1 1
MTU 1500 1500
Control word disabled disabled
PW type Ethernet Ethernet
VCCV CV type 0x2 0x2
(LSP ping verification) (LSP ping verification)
VCCV CC type 0x6 0x6
(router alert label) (router alert label)
(TTL expiry) (TTL expiry)
Incoming Status (PW Status TLV):
Status code: 0x0 (Up) in Notification message
Outgoing Status (PW Status TLV):
Status code: 0x0 (Up) in Notification message
MIB cpwVcIndex: 4294705153
Create time: 27/04/2011 10:14:45 (00:00:34 ago)
Last time status changed: 27/04/2011 10:15:16 (00:00:02 ago)
MAC withdraw message: send 0 receive 0
P2MP-PW:
FEC Local Remote
Label NULL (inclusive tree) NULL (inclusive tree)
P2MP ID 1 1
Flags 0x00 0x00
PTree Type RSVP-TE RSVP-TE
Tunnel ID 1000 1000
Ext. Tunnel ID 192.168.0.1 192.168.0.2
P2MP forwarding: enabled
Static MAC addresses:
Statistics:
packets: received 1000 (unicast 1000), sent 0
bytes: received 128000 (unicast 128000), sent 0
MAC move: 10
DHCPv4 snooping: disabled
IGMP Snooping profile: none
VPN-ID: 1
VFI Statistics:
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
327
Multipoint Layer 2 Services Commands
show l2vpn bridge-domain (VPLS)
To Next Page
Loading...
Need help?
General
