List of Access PWs:
List of VFIs:
VFI 1
Neighbor 10.1.1.1 pw-id 1, state: up, Static MAC addresses: 0
Statistics:
packets: received 1000 (unicast 1000), sent 0
bytes: received 128000 (unicast 128000), sent 0
MAC move: 10
The following sample output shows the summary information for the bridge domain:
RP/0/RSP0/CPU0:router# show l2vpn bridge-domain summary
Number of groups: 1, bridge-domains: 2, Up: 2, Shutdown: 0
Default: 0, pbb-edge: 1, pbb-core: 1
Number of ACs: 1 Up: 1, Down: 0
Number of PWs: 0 Up: 0, Down: 0
The following sample output shows the summary information for the bridge domain including number of
bridge-domains with P2MP PW enabled:
RP/0/RSP0/CPU0:router# show l2vpn bridge-domain summary
Number of groups: 1, bridge-domains: 1, Up: 1, Shutdown: 0
Default: 1, pbb-edge: 0, pbb-core: 0
Bridge-domains with P2MP PW enabled: 1
Number of ACs: 3 Up: 3, Down: 0
Number of PWs: 2 Up: 2, Down: 0, Standby: 0
This table describes the significant fields shown in the display.
Table 10: show l2vpn bridge-domain summary Command Field Descriptions
DescriptionField
Number of configured bridge domain groups is
displayed.
Number of groups
Number of configured bridge domains is displayed.bridge-domains
Number of bridge domains that are in Shutdown state
is displayed.
Shutdown
Number of attachment circuits that are in Up state
and Down state are displayed.
Number of ACs
Number of pseudowires that are in Up state and Down
state are displayed. This includes the VFI pseudowire
and the access pseudowire.
Number of PWs
This example shows the sample output of a configured flow label:
RP/0/RSP0/CPU0:router# show l2vpn bridge-domain detail
Bridge group: g1, bridge-domain: d1, id: 0, state: up, ShgId: 0, MSTi: 0
……
PW: neighbor 3.3.3.3, PW ID 2, state is up ( established )
PW class class1, XC ID 0x1000002
Encapsulation MPLS, protocol LDP
PW type Ethernet, control word disabled, interworking none
PW backup disable delay 0 sec
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
332
Multipoint Layer 2 Services Commands
show l2vpn bridge-domain (VPLS)
To Next Page
Loading...
Need help?
General
