VPLS-ID: (auto) 100:1001
L2VPN Router ID: 1.1.1.1
PW: neighbor 2.2.2.2, PW ID 100:1001, state is up ( established )
PW class not set, XC ID 0xfff8000f
Encapsulation MPLS, Auto-discovered (BGP), protocol LDP
Source address 1.1.1.1
PW type Ethernet, control word disabled, interworking none
Sequencing not set
PW Status TLV in use MPLS Local Remote
------------ ------------------------------ -------------------------
…
------------ ------------------------------ -------------------------
Incoming Status (PW Status TLV):
Status code: 0x0 (Up) in Notification message
MIB cpwVcIndex: 0
Create time: 20/06/2016 19:40:49 (00:23:06 ago)
Last time status changed: 20/06/2016 19:40:51 (00:23:04 ago)
MAC withdraw messages: sent 0, received 0
Table-policy Name: fwd1
Forward-class: 1
Static MAC addresses:
Statistics:
packets: received 0 (unicast 0), sent 0
bytes: received 0 (unicast 0), sent 0
MAC move: 0
Storm control drop counters:
packets: broadcast 0, multicast 0, unknown unicast 0
bytes: broadcast 0, multicast 0, unknown unicast 0
DHCPv4 snooping: disabled
IGMP Snooping profile: none
MLD Snooping profile: none
VFI Statistics:
drops: illegal VLAN 0, illegal length 0
Related Commands
DescriptionCommand
Clears the MAC addresses and restarts the bridge
domains on the router.
clear l2vpn bridge-domain (VPLS), on page 244
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
337
Multipoint Layer 2 Services Commands
show l2vpn bridge-domain (VPLS)
To Next Page
Loading...
Need help?
General
