This example shows how to enable BGP in the EVPN EVI configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# evpn
RP/0/RSP0/CPU0:router(config-evpn)# evi 2
RP/0/RSP0/CPU0:router(config-evpn-evi)# bgp
RP/0/RSP0/CPU0:router(config-evpn-evi-bgp)#
Related Commands
DescriptionCommand
Enters EVPN configuration mode.evpn, on page 400
Enters the EVPN EVI configuration mode to configure optional BGP
settings for a bridge domain or EVI.
evi, on page 398
Specifies a route target for the VFI, PBB EVPN or EVPN bridge
domain.
route-target, on page 308
rd
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
390
Provider Backbone Bridge Commands
bgp (EVPN)
To Next Page
Loading...
Need help?
General
