RP/0/RSP0/CPU0:router(config-evpn-ac)# ethernet-segment
RP/0/RSP0/CPU0:router(config-evpn-ac-es)#
Related Commands
DescriptionCommand
Enters the EVPN Interface configuration mode.interface (EVPN), on page 410
Configures the backbone source MAC address.backbone-source-mac, on page 387
Sets the Ethernet segment identifier value.identifier, on page 407
Sets the load balancing mode of a physical port or bundle to
active-active.
load-balancing-mode, on page 415
Specifies the list of service identifiers as active and standby
services.
service-carving, on page 431
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
397
Provider Backbone Bridge Commands
ethernet-segment
To Next Page
Loading...
Need help?
General
