Task ID
OperationsTask ID
read, writeinterface
Examples
The following example shows how to configure the bringup delay:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)#spanning-tree mst A
RP/0/RSP0/CPU0:router(config-mstp)# bringup delay for 20 seconds
Related Commands
DescriptionCommand
Enables debugging for sent and received MSTP packets.debug spanning-tree mst packet, on page 479
Enables debugging protocol-state changes such as port role
or state changes, topology change notification.
debug spanning-tree mst protocol-state, on
page 481
Enters the MSTP configuration submodespanning-tree mst, on page 623
Displays the multiple spanning tree protocol status
information.
show spanning-tree mst, on page 589
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
470
Multiple Spanning Tree Protocol Commands
bringup delay
To Next Page
Loading...
Need help?
General
