Examples
The following example shows how to set the port cost to 10000:
RP/0/RSP0/CPU0:router(config-mstag-if-inst)# cost 10000
Related Commands
DescriptionCommand
Enables MSTAG packet debugging.debug spanning-tree mstag packet, on page
483
Enables Resilient Ethernet Protocol (REP) Access Gateway
debugging commands.
debug spanning-tree repag packet, on page
493
Enter the MSTAG interface configuration submode, and enables
MSTAG for the specified port.
interface (MSTAG/REPAG), on page 523
Enters MSTAG Instance configuration mode or REPAG
Instance configuration mode.
instance (MSTAG/REPAG), on page 515
Enters the MST Access Gateway configuration submode.spanning-tree mstag, on page 625
Enters the Resilient Ethernet Protocol Access Gateway
(REPAG) configuration submode.
spanning-tree repag, on page 633
Displays the values currently used for populating the BPDUs
sent by all ports.
show spanning-tree mstag, on page 604
Displays the values currently used for populating the BPDUs
sent by all ports.
show spanning-tree repag, on page 617
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
474
Multiple Spanning Tree Protocol Commands
cost
To Next Page
Loading...
Need help?
General
