Task ID
OperationsTask ID
read, writeinterface
Examples
The following example shows how to enter the MSTAG interface configuration submode:
RP/0/RSP0/CPU0:router(config-mstag)# interface GigabitEthernet0/2/0/30.1
RP/0/RSP0/CPU0:router(config-mstag-if)#
Related Commands
DescriptionCommand
Enables MSTAG packet debugging.debug spanning-tree mstag packet, on page
483
Enables Resilient Ethernet Protocol (REP) Access Gateway
debugging commands.
debug spanning-tree repag packet, on page
493
Enters the MST Access Gateway configuration submode.spanning-tree mstag, on page 625
Enters the Resilient Ethernet Protocol Access Gateway
(REPAG) configuration submode.
spanning-tree repag, on page 633
Displays the values currently used for populating the BPDUs
sent by all ports.
show spanning-tree mstag, on page 604
Displays the values currently used for populating the BPDUs
sent by all ports.
show spanning-tree repag, on page 617
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
524
Multiple Spanning Tree Protocol Commands
interface (MSTAG/REPAG)
To Next Page
Loading...
Need help?
General
