Examples
The following example shows how to enable fragmentation over an interface tunnel.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface tunnel-ip 400
RP/0/RSP0/CPU0:router(config-if)# tunnel dfbit disable
Related Commands
DescriptionCommand
Specifies a tunnel interface's destination address.tunnel destination, on page 43
Configures the encapsulation mode of the tunnel interface.tunnel mode, on page 51
Sets a tunnel interface's source address.tunnel source, on page 53
Specifies the value of the TOS field in the tunnel encapsulating
packets.
tunnel tos, on page 55
Configures the Time-To-Live (TTL) for packets entering the
tunnel.
tunnel ttl, on page 57
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
50
Generic Routing Encapsulation Commands
tunnel dfbit
To Next Page
Loading...
Need help?
General
