Task ID
OperationsTask ID
read, writeinterface
Examples
The following example shows how to configure interface tunnel:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface tunnel-ip 400
RP/0/RSP0/CPU0:router(config-if)#tunnel mode gre ipv4
Related Commands
DescriptionCommand
Specifies a tunnel interface's destination address.tunnel destination, on page 43
Sets a tunnel interface's source address.tunnel source, on page 53
Specifies the value of the TOS field in the tunnel encapsulating
packets.
tunnel tos, on page 55
Configures the Time-To-Live (TTL) for packets entering the
tunnel.
tunnel ttl, on page 57
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
52
Generic Routing Encapsulation Commands
tunnel mode
To Next Page
Loading...
Need help?
General
